Banksman on Site: What They Do and When You Need One
What does a banksman do and when do you need one? A practical UK guide to reversing vehicles, the law, signals, training and writing it into your RAMS.

Do you need a banksman every time a lorry backs onto site? And if you use one, what does your RAMS need to say about them? It's a question often answered by habit, which is how you end up with whoever's nearest in a hi-vis vest waving a delivery into a busy gateway.
A banksman is a control measure, not a box to tick. HSE's guidance puts them after removing reversing and keeping people and vehicles apart, and when you do use one they must be trained, authorised and given a safe place to stand.
Key takeaway: plan reversing out first, keep people and vehicles apart second, and use a trained, authorised banksman only where vehicles still have to move near people. Then write who, where and which signals into your RAMS.
What is a banksman?
HSE describes banksmen as operatives trained to direct vehicle movement on or around site, and notes they're often called traffic marshals (HSE: banksmen and signallers). On a typical job that means guiding delivery lorries, tippers, dumpers and excavators when the driver can't see everything around them, and keeping people on foot out of the way.
Two roles get mixed up:
- Banksman, vehicle marshal or traffic marshal. Directs vehicles and mobile plant, usually while they reverse or manoeuvre in a tight space.
- Signaller. In HSE's construction FAQ, a signaller directs crane drivers during lifting operations. That's a lifting role with its own rules, covered in our LOLER regulations guide.
HSE uses the words loosely (its reversing guidance calls a banksman a "trained signaller"), so focus on what the person is directing and whether they're trained for it.
Is a banksman a legal requirement?
No regulation says every vehicle needs a banksman. The law requires vehicles and people to be kept safe from each other, and a banksman is one way to do that.
On construction sites the duties sit in the Construction (Design and Management) Regulations 2015:
- Regulation 27 (traffic routes). A site must be organised so that, so far as is reasonably practicable, pedestrians and vehicles can move without risks to health or safety. Where separating them isn't reasonably practicable, other protection and effective warning arrangements are needed (CDM 2015 regulation 27).
- Regulation 28 (vehicles). Where someone may be endangered by a moving vehicle, steps must be taken to warn them, by the driver, by the person directing them when the driver doesn't have full visibility, or both (CDM 2015 regulation 28). That second person is your banksman.
Outside construction (depots, yards and loading bays on a facilities management contract), regulation 17 of the Workplace (Health, Safety and Welfare) Regulations 1992 requires a workplace to be organised so pedestrians and vehicles can circulate safely.
Your risk assessment under regulation 3 of the Management of Health and Safety at Work Regulations 1999 decides whether a banksman is the right control. HSE's position is that banksmen can be used for reversing vehicles, but only if trained and authorised, and only where other control measures aren't possible, because segregation sits at the top of the hierarchy.
When do you need a banksman on site?
Work through the options like a hierarchy. HSE's guidance puts a banksman at the end, not the start.
- Remove the need to reverse. One-way systems, drive-through loading points and turning circles take reversing out of the job (HSE: safe driving, reversing).
- Cut vehicle movements. Park workers' and visitors' vehicles away from the work area, control entry, and plan storage so deliveries don't cross the site (HSE: traffic management on site).
- Keep people and vehicles apart. Separate gates, firm walkways, signed crossing points and barriers between roadway and walkway.
- Plan the reversing you can't avoid. Mark out reversing areas, keep everyone else clear, and check mirrors, cameras and reversing alarms work.
- Then add a banksman where vehicles still have to move near people and the driver can't see everything they need to.
Your risk assessment will often point to a banksman for:
- HGV deliveries reversing into a site entrance off a public road
- tippers and dumpers backing up to a stockpile or excavation with people nearby
- plant manoeuvring in a congested area or shared yard
- vehicle movements in poor light where people can't be kept out of the area
Two HSE cautions are worth knowing. The use of signallers isn't allowed in some industries because of vehicle size and how hard drivers find it to see them. And it's unlikely any single measure will be enough on its own, so a banksman works alongside the layout, lighting and driver aids, not instead of them.
What does a banksman do?
HSE's reversing guidance sets out what a banksman needs to work safely:
- Keep the reversing area clear of people on foot, and guide the driver.
- Use a clear, agreed system of signals.
- Stay visible to the driver at all times.
- Stand in a safe position, guiding the vehicle without being in its way.
- Wear very visible clothing, such as a reflective vest.
- Make sure drivers know to stop immediately if they lose sight of the banksman.
- Use radios where hand signals alone won't do the job.
The banksman directs the movement and nothing else. If they're also unloading or checking the delivery note, they aren't watching the vehicle.
What hand signals should a banksman use?
The Health and Safety (Safety Signs and Signals) Regulations 1996 set minimum requirements for hand signals (Schedule 1, Part IX) and verbal communication (Part VIII). HSE's construction FAQ points to its guidance, L64, for the standard signals. Agree them before work starts and brief everyone involved, including visiting drivers. Our guide to hazard symbols and safety signs covers how the same regulations treat signs.
Does a banksman need a ticket or qualification?
HSE's construction traffic management page says people who direct vehicle movements must be trained and authorised to do so. The HSE pages linked here don't name a specific card, but many principal contractors set their own training rules, so check before you send someone. Treat "authorised" as meaning the person has been chosen and named for the task and knows that site's routes and signals.
What does this mean for a small contractor day to day?
Banksman arrangements usually go wrong between the plan and the day. The RAMS says "banksman to be used", then the delivery arrives early, the trained person is on a break, and someone else steps in. A few habits close that gap:
- Book deliveries and tell the supplier where to stop and what the site rules are.
- Name the banksman for each task, plus a back-up.
- Brief visiting drivers at the gate. HSE recommends induction for drivers, workers and visitors, and sending instructions to visitors before they arrive.
- Log near misses with reversing vehicles. Our near miss reporting guide explains what counts.
- Run a toolbox talk on signals and the stop rule when the vehicle pattern on site changes.
Reversing stays firmly on HSE's radar. In an October 2026 prosecution, inspectors found a firm had no suitable traffic management system and no adequate precautions for reversing vehicles.
How to write banksman arrangements into your RAMS
"Banksman to be used" doesn't control anything. The method statement should explain how the movement will happen. Include:
- Which vehicles and plant will move, where and when.
- How reversing is avoided or limited, and how people are kept apart.
- Who the banksman is (by role), how they're trained and authorised, and who covers.
- Where the banksman stands, and the exclusion zone.
- The agreed signals, any radio channel, and the rule that the driver stops if they lose sight of the banksman.
- The lighting, hi-vis and vehicle aids that must be working.
- How visiting drivers are briefed.
Reference table: where banksman arrangements belong in your documents
- RAMS. Covers: this task's vehicle movements, the controls, and the banksman's role, position, signals and exclusion zone.
- Construction phase plan. Covers: site-wide traffic arrangements such as entrances, routes, one-way systems, deliveries and site rules. See our construction phase plan guide.
- Lift plan. Covers: lifting operations, including the signaller. Under LOLER 1998 regulation 8, every lifting operation must be properly planned by a competent person, appropriately supervised and carried out safely.
- Safe system of work. Covers: routine vehicle movements in a yard, depot or service area that isn't a construction project. See safe system of work documents.
- Site induction. Covers: routes, signals and rules for drivers, workers and visitors. See our site induction pack checklist.
Getting banksman arrangements into your documents faster
swiftRMS writes RAMS, construction phase plans and safe systems of work for UK contractors. Describe the job (a muck-away with tipper lorries, plant on a tight urban site, deliveries into a shared yard) and AI RAMS drafts the vehicle controls, banksman arrangements and signals into the method statement in minutes. Principal contractors can set out site-wide traffic arrangements in a construction phase plan.
Everything swiftRMS produces is an AI-generated draft. A competent person must review it, check it against the real site and sign it off before work starts. A good document helps, but it's the banksman standing in the right place, and a driver who stops when they can't see them, that keeps people safe.
Try swiftRMS free and generate a RAMS for your next delivery or plant job. No card needed.
Frequently asked questions
Is a banksman a legal requirement?
No law requires a banksman for every vehicle. CDM 2015 and the Workplace Regulations 1992 require sites to be organised so people and vehicles can move safely. HSE says segregation comes first and banksmen should only be used where other controls aren't possible. If you do use one, they must be trained and authorised.
What is the difference between a banksman and a signaller?
In HSE's construction guidance, a banksman (also called a traffic marshal) directs vehicles and mobile plant moving on or around site. A signaller directs crane drivers during lifting operations, which must be planned under LOLER 1998. HSE sometimes uses the words interchangeably, so check what the person is actually being asked to direct.
Does a banksman need a qualification?
HSE says banksmen must be trained and authorised for the task, but its guidance pages don't name a specific card or course. Many principal contractors set their own training requirements in their site rules, so check before you arrive. Whatever the training, the banksman must know that site's routes and agreed signals.
What should a driver do if they lose sight of the banksman?
Stop immediately. HSE's reversing guidance says drivers should know to stop as soon as they lose sight of the signaller, and the banksman must stay visible to the driver at all times. Write this rule into your RAMS and brief it to every driver, including visiting delivery drivers.
Official resources
Recommended Tools & Resources
Save hours on health & safety paperwork — generate documents with swiftRMS.
Create a professional RAMS in under 2 minutes — UK legislation cited automatically.
From £49/mo. CDM 2015 referenced. 14-day free trial, no card needed.
The UK RAMS tools side by side: features, pricing and speed.
12+ trade-specific UK risk assessment templates with hazards and legislation.